CyBENCH :: Robotics - Electronics Resources
Home Projects Cybot ScrapBots Part Salvage Site Map Links
  PROBLEM PAGES
Project Index
Part 1
Part 2
Part 3
Part 4
Part 5
Part 6
  SITE INFO
Contact Info
Disclaimer

The CYBOT RF Remote control


Part 8 - Testing the Remote System Stage 6


POWER

Apply Power to the Receiver Board, I had a PP3 battery snap attached to mine.



NO LEDS should be illuminated when first powered.

Ensure the battery is installed in the keyfob and the polarity is correct.

Switch on Cybot's power, put it in a clear area and stand back.

When the wand is touched on a command terminal, cybot should respond accordingly.


USING THE TEST LED

If you need to test the output of the receiver, attach the test led.
The use and installation of the test led is detailed in the main project area for the remote project.

The following images illustrate the signal levels in the different modes:


OFF / STOP

FORWARD

REVERSE

LEFT TURN

RIGHT TURN

SPIN




CYBOT COMPLETE WITH RF RECEIVER
(notice that the slots in the PCB fit snuggly between cybot's antennae)


ENJOY....!

Please email me to let me know if all went well, or bad